Description
- Single Adjusting JackPlate
- Made of high strength polished Aircraft Quality Aluminum
- Bronze and Brass hardware eliminate binding
- Adjusts easily by turning one steel bolt
- Offers 4 inches of adjustable Vertical movement
- Available in 3, 4, 6, 8 and 10 inches of setback
- Weighs 27 lbs
- 225 Maximum Horsepower
- 1 Year Unconditional Warranty against manufacturer defects
JackPlates are the perfect solution for long shaft engines with a short shaft transom! The engine side holes of the JackPlate is drilled 1.500 inches higher than the transom side. Combined with the 4 inches of adjustable vertical lift you can obtain 5.500 inches at a maximum height to raise your long shaft engine and make it workable on a short shaft transom boat!
Here are the pre-drilled hole dimensions listed below in inches:
- Pre-drilled holes for 1/2” stainless hardware
- 12 7/8” across the top two holes from center to center
- 9 7/8” across the bottom two holes from center to center
- 8” of vertical distance between the top holes and bottom mounting holes
